Extron Electronics IN3600 Series Preliminary Manual - Manual (Page 8)

4
IN3606 / IN3656 / IN3666 OPERATION MANUAL - REV. 1.1 11/27/99 ©1998 - INLINE, INC.
To set Input Scan Options - Hold down INPUT3 button during power-up:
A. BLANK LED goes solid
B. Letting go of INPUT3, BLANK LED flashes
C. Press one of the INPUT buttons to select inputs to scan:
INPUT1 Disable scanning (If entered, skips to end)
INPUT2 Scan Inputs 1 to 2
INPUT3 Scan Inputs 1 to 3
INPUT4 Scan Inputs 1 to 4
(And for the IN3656 switcher:)
INPUT5
Scan Inputs 1 to 5
INPUT6 Scan Inputs 1 to 6
(INPUT1 LED will go on to show scan enabled and 2-6 LED will go on to show to what
input)
D. The BLANK LED now flashes at a slower rate
E. Switches INPUT1 through INPUT4 are toggling options:
INPUT1 Add 2.5 seconds of scan delay
INPUT2 Add 5.0 seconds of scan delay
INPUT3 Add 10.0 seconds of scan delay
INPUT4 Add 20.0 seconds of scan delay
(Up to 37.5 seconds of delay can be programmed in)
F. Depressing BLANK button saves configuration and Blank LED goes off
To set RGB Delay Options - Hold down INPUT4 button during power-up:
A. BLANK LED goes solid
B. Letting go of INPUT4, BLANK LED flashes
C. Switches INPUT1 through INPUT4 are toggling options:
INPUT1 Add 0.5 second of RGB delay
INPUT2 Add 1.0 seconds of RGB delay
INPUT3 Add 2.0 seconds of RGB delay
INPUT4 Add 4.0 seconds of RGB delay
(Up to 7.5 seconds of delay can be programmed in)
D. Depressing BLANK button saves configuration and Blank LED goes off
To set RS-232 Serial Control Baud Rate - Hold down BLANK button during power-up :
A. BLANK LED goes solid
B. Letting go of BLANK, BLANK LED flashes
C. Switches INPUT1 through INPUT4 select baud rate:
INPUT1 on = 1200 baud
INPUT2 on = 2400 baud
INPUT3 on = 4800 baud
INPUT4 on = 9600 baud
D. Depressing BLANK button saves configuration and Blank LED goes off
Calling these up will also show present settings. (i.e. INPUT2 settings, INPUT2 LED may be on showing
that the front panel is already enabled)