AEG S63300KDX0 - Manual (Page 33)

2
1
• Unscrew the upper pin and screw it on
the opposite side.
h1 h2
h3 h4
h5 h6
• Remove the handle. Unscrew the top
handle bracket from the handle rod
(h1). Unscrew the bottom handle
bracket from the door (h2)
• Unscrew the top handle bracket from
the door (h3).
• Re-screw the handle bracket on the
door (h4). Turn the handle bracket
with the handle and screw them to the
door (h5) and the fitted handle bracket
(h6)
• Re-insert the door on the lower hinge
pivot .
• Re-insert the door on the upper hinge
pivot slightly tilting the door.
• Screw the lower hinges.
• Refit the plinth.
• Stand the appliance upright.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact
the nearest After Sales Service Force.
The After Sales Service specialist will car-
ry out the reversibility of the doors at
your cost.
9. NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
ENGLISH
33