AEG S63300KDX0 - Manual (Page 32)

8.4 Rear spacers
2
4
3
1
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
8.5 Levelling
Accurate levelling prevents the vibration
and noise of the appliance during opera-
tion. To adjust the height of the appli-
ance loosen or tighten the two adjusta-
ble front feet.
8.6 Door reversibility
3
4
1
5
2
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power
socket.
• Tilt back the appliance carefully so
that the compressor cannot touch the
floor.
• Remove the plinth.
• Unscrew and remove the lower hinges.
• Remove the door.
• Unscrew the pin and screw it on the
opposite side.
• Remove the cap and position it on the
opposite side.
32 www.aeg.com