Extron Electronics DSC HD-3G A Setup Guide - Manual (Page 2)

DSC HD-3G A • Setup Guide (Continued)
2
Front Panel Overview
DSC HD-3G A
AUTO-
IMAGE
Extron
MENU
ENTER HOLD FOR 720p 1080i
INPUT OUTPUT
SYNC
2.97 Gbps
1.485 Gbps
270 Mbps
SIGNAL
2CH-LPCM
MULTI-CH PCM
ANALOG
CONFIG
3 4 5 6 1 2
a
Status LED — Lights steadily amber when there is power but no signal, blinks amber every 3 seconds when the unit is in
standby mode, and lights steadily green when both power and an input signal are present.
b
USB configuration port — Connect a control system or computer to this mini USB port (cable not supplied) for device
configuration, control, and firmware upgrading.
c
Input LEDs — The Signal LED lights to indicate presence of an input signal. An audio signal LED (2CH-LPCM, Multi-CH
PCM, or Analog) lights to indicate the type of audio signal (two-channel LPCM, multi-channel PCM, or analog) if present.
d
Output LEDs — Light to indicate the presence of sync and the rate specified for the output:
z
Sync: Sync is present (does not light if video sync is muted).
z
2.97 Gbps: SMPTE 424M
z
1.485 Gbps: SMPTE 292M
z
270 Mbps: SMPTE 259M
e
Menu and Enter buttons — Let you access the OSD and select submenus and options from the menus.
f
Navigation buttons — Press these right , left , up  , and down

arrow buttons to step through the OSD submenus,
to lock the front panel (see the next section), perform Auto-Image (press ), and reset the output rate (hold

for 5 seconds).
Locking the Front Panel (Executive Mode)
To prevent unauthorized access or accidental changes to DSC settings, you can lock the front panel controls, making control
available only by SIS commands. (The default state is unlocked.) You can lock and unlock the front panel as follows:
z
Using the front panel buttons: To lock, press the Menu and

buttons simultaneously and hold them until the OSD
displays Executive Mode Enabled (approximately 5 seconds). To unlock, repeat this process.
z
SIS commands: To lock (enable executive mode), enter 1X. To unlock (disable executive mode), enter 0X.
Configuring the DSC HD-3G A
The DSC HD-3G A can be configured through a host connected to
the RS-232 or USB port, using Extron PCS Windows-based control
software (available at no charge at
www.extron.com ) or SIS
commands (see page 4 for a selection of basic commands). You
can also configure it using the OSD menu system, described below.
On-Screen Display (OSD) Menu System
The OSD menu system consists of seven submenus and two
information screens. To access the menus, press the front panel
Menu button. With the main menu displayed, use the arrow buttons
to step through the submenus and submenu options. Press the
Enter button to select items that you highlight. Communication and
Device Info screens are read-only and do not provide selections.
• Quick Setup • User Presets • Picture Controls
• Input • Output • Audio
• Advanced • Communication • Device Info.
NOTE: The OSD times out and closes after 1 minute if no
buttons are pressed.