beautypg.com

Zanussi ZBA15020SA User Manual

Page 15

background image

Problem

Possible cause

Solution

The product temperature is too high.

Let the product temperature decrease to

room temperature before storage.

The room temperature is too high.

Decrease the room temperature.

Water flows on the rear plate of

the refrigerator.

During the automatic defrosting proc-

ess, frost defrosts on the rear plate.

This is correct.

Water flows into the refrigerator.

The water outlet is clogged.

Clean the water outlet.

Products prevent that water flows into

the water collector.

Make sure that products do not touch

the rear plate.

Water flows on the ground.

The melting water outlet does not flow

in the evaporative tray above the com-

pressor.

Attach the melting water outlet to the

evaporative tray.

The temperature in the appliance

is too low.

The temperature regulator is not set

correctly.

Set a higher temperature.

The temperature in the appliance

is too high.

The temperature regulator is not set

correctly.

Set a lower temperature.

The door is not closed correctly.

Refer to "Closing the door".

The product temperature is too high.

Let the product temperature decrease to

room temperature before storage.

Many products are stored at the same

time.

Store less products at the same time.

There is no cold air circulation in the

appliance.

Make sure that there is cold air circula-

tion in the appliance.

Replacing the bulb

If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as shown in

the figure.

4. Replace the bulb with one of the same power and

specifically designed for household appliances (the

maximum power is shown on the light bulb cover).

5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.

Contact the Service Center.

15

This manual is related to the following products: