beautypg.com

What to do if – Zanussi ZBA15020SA User Manual

Page 14

background image

Defrosting of the refrigerator

Frost is automatically eliminated from the evaporator of

the refrigerator compartment every time the motor com-

pressor stops, during normal use. The defrost water

drains out through a trough into a special container at the

back of the appliance, over the motor compressor, where

it evaporates.

It is important to periodically clean the defrost water drain

hole in the middle of the refrigerator compartment channel

to prevent the water overflowing and dripping onto the

food inside. Use the special cleaner provided, which you

will find already inserted into the drain hole.

Periods of non-operation

When the appliance is not in use for long periods, take the

following precautions:
• disconnect the appliance from electricity supply
• remove all food
• defrost (if foreseen) and clean the appliance and all ac-

cessories

• leave the door/doors ajar to prevent unpleasant smells.

If the cabinet will be kept on, ask somebody to check it

once in a while to prevent the food inside from spoiling in

case of a power failure.

What to do if…

Warning! Before troubleshooting, disconnect the

mains plug from the mains socket.

Only a qualified electrician or competent person must do

the troubleshooting that is not in this manual.

Important! There are some sounds during normal use

(compressor, refrigerant circulation).

Problem

Possible cause

Solution

The appliance does not operate.

The lamp does not operate.

The appliance is switched off.

Switch on the appliance.

The mains plug is not connected to the

mains socket correctly.

Connect the mains plug to the mains

socket correctly.

The appliance has no power. There is

no voltage in the mains socket.

Connect a different electrical appliance

to the mains socket.

Contact a qualified electrician.

The lamp does not work.

The lamp is in stand-by.

Close and open the door.

The lamp is defective.

Refer to "Replacing the lamp".

The compressor operates contin-

ually.

The temperature is not set correctly.

Set a higher temperature.

The door is not closed correctly.

Refer to "Closing the door".

The door has been opened too fre-

quently.

Do not keep the door open longer than

necessary.

14

This manual is related to the following products: