Bell & Gossett P81629F Series 80 In-Line Mounted Centrifugal Pump - Manual (Page 7)

Decals
Make sure your pump has these safety instruction decals and that they are located as this
figure shows. If the decals are missing or illegible, contact your local sales and service
representative for a replacement.
All series 80 Pumps Series 80 with optional ITSC
P70643
P70644
P70642
EYEBOLTS OR LIFTING
LUGS IF PROVIDED ARE
FOR LIFTING ONLY THE
COMPONENTS TO WHICH
THEY ARE ATTACHED.
FAILURE TO FOLLOW
INSTRUCTIONS COULD
RESULT IN INJURY OR
DEATH.
DO NOT RUN PUMP DRY.
SEAL DAMAGE MAY OCCUR.
INSPECT PUMP SEAL
REGULARLY FOR LEAKS.
REPLACE AS REQUIRED.
FOR LUBRICATION
REQUIRMENTS, CONSULT
SERVICE INSTRUCTIONS.
FAILURE TO FOLLOW
INSTRUCTIONS COULD
RESULT IN INJURY OR
PROPERTY DAMAGE.
ROTATING COMPONENTS
DISCONNECT AND LOCK
OUTPOWER BEFORE
SERVICING.
DO NOT OPERATE WITHOUT
ALL GUARDS IN PLACE.
CONSULT INSTALLATION
AND SERVICE INSTRUCTION
SHEET BEFORE OPERATING
OR SERVICING.
FAILURE TO FOLLOW
INSTRUCTIONS COULD
RESULT IN INJURY OR
DEATH. S11547
ELECTRICAL SHOCK HAZARD.
TURN OFF AND LOCKOUT ALL
POWER SOURCES PRIOR TO
SERVICING PANEL.
FAILURE TO FOLLOW THESE
INSTRUCTIONS COULD RESULT
IN SERIOUS PERSONAL INJURY,
DEATH, AND/OR PROPERTY
DAMAGE.
WARNING
Make sure that all safety instruction decals are always clearly visible and readable.
User safety
General safety rules
These safety rules apply:
• Always keep the work area clean.
• Pay attention to the risks presented by gas and vapors in the work area.
• Avoid all electrical dangers. Pay attention to the risks of electric shock or arc flash
hazards.
• Always bear in mind the risk of drowning, electrical accidents, and burn injuries.
Safety equipment
Use safety equipment according to the company regulations. Use this safety equipment
within the work area:
• Hard hat
• Safety goggles, preferably with side shields
• Protective shoes
• Protective gloves
• Gas mask
• Hearing protection
• First-aid kit
• Safety devices
NOTICE:
Never operate a unit unless safety devices are installed. Also see specific information
about safety devices in other chapters of this manual.
Introduction and Safety
Series 80 Installation, Operation, and Maintenance Manual 5