Xylem Expert 700 - Manual (Page 2)

Manual
GB Manual Expert 700 0712
As our products are continuously improved, we reserve the right to make
any change in the stated specifications and dimensions without prior notice.
MJK Automation A/S
Byageren 7
DK-2850 Naerum
Denmark
Tel.: +45 45 56 06 56
Fax: +45 45 56 06 46
[email protected]
www.mjk.com
Contents:
Approvals 2
Introduction 2
Product identification 2
Safety instructions 3
Hazardous areas 3
Repair 3
Mechanical mounting 3
Electrical mounting 5
Designation of wires, cutting & stripping the cable 5
Designations: 6
Please note the following installation instructions: 6
Data Sheet for Expert™ 700 Level Transmitter 7
Dimensions 8
Accessories 8
MJK Read Link 8
Approvals
CE Certificate of conformity
This product complies with the requirements concerning electromagnetic compatibility (EMC) stipulated in Council
directive no. 89/336/EEC of 3rd May 1989, altered at directive no. 92/31/EEC, on the approximation of the laws of
the Member States relating to electromagnetic compatibility.
We declare that the product complies to the values stipulated in EN61000-6-1/ to 6-4
Introduction
Thank you for choosing Expert TM Level Transmitter. We have done everything possible to make a level
transmitter that can fulfil all your demands.
Expert TM Level Transmitter is suitable for all kinds of level measurements. It can control and supervise levels in wells and
tanks - including aggressive and polluted media.
The Expert TM Level Transmitter is both easy to install and put into service, but read this manual first - then you will get
the most benefits from the Expert TM Level Transmitter right from the beginning.
You can always contact your representative or the MJK Service Hotline for advice and guidance. Also, take a look at
http://www.mjk.com
Expert TM Level Transmitter is registered trademark of MJK. Thank you for choosing MJK Automation A/S as your
supplier of hydrostatic level transmitter.
Product identification
It is very important for the overall measuring accuracy that the pressure transmitter has the correct pressure range.
Check that the item(s) delivered corresponds to the ordered item(s) by means of the information on the label on the
packing:
On the model Expert 700 transmitters, the pressure ranges together with the corresponding part numbers are
printed on a label on the transmitter housing. For all versions the pressure range is indicated on the label.