Xylem CVD-2000 CELLULAR AUTODIALERS - Manual (Page 11)

Global Water
800-876-1172
• globalw.com
- 11 -
6. STEP 4 - Repeat steps 1-3 for each number to be programmed in each
location. Select any of eight (8) location numbers in Step 1
(SELECT: 1-8) for each number to be programmed.
7. STEP 5 - When you are done programming all desired telephone and/or
pager numbers, press “0” to exit this section.
NOTE: IF YOU ENTER THE WRONG CHOICE, PRESS “M” KEY
REPEATEDLY AND RETURN TO THE “PROGRAM MODE”,
THEN SELECT THE SECTION TO CHANGE (“1” ACCEPT
SECTION, “2”
b) Programming Auxiliary Information
The dialer is preset at the factory to typical telephone line (TLINE), PBX, Dialing
attempts and Message Repeat options. If you choose to accept the following
default prompts, simply press “2” to scroll to the next section. If your phone
system requires dialing a digit to get an outside line or dial tone, similar to
PBX, then turn PBX on and enter digit to program.
PRESETS
T-LINE…………….TONE
PBX………………….OFF
ATTEMPTS…………….2
MESSAGE……………...2
To change the presets, follow these steps.
1. T-LINE
(a) The LCD will display: PROGRAM: T-LINE
1(YES) 2(NO)
(b) Press “1” to program T- LINE.
(c) Press “2” to scroll to the next section.
(d) The LCD will display: PROGRAM: T-LINE
1(TONE) 2(PULSE)
(e) Press “1” for TONE. Press “2” for PULSE.
2. PBX
(a) The LCD will display: PROGRAM: PBX
1(ON) 2(OFF)
(b) Step 1: Press “1” for ON. Press “2” for OFF.
(c) Step 2: If “1” is entered, the LCD will display:
PROGRAM: PBX
ENTER PBX NUMBER
(d) Enter PBX number (1 digit).