YSI IQ SensorNet MIQ/A-MOD Module - Manual (Page 23)

MIQ/(A-)MOD Interface for the Modbus RTU
23 ba76021e01 01/2012
3.5.3 Changing the assignment of sensor numbers
You want to change the assignment of sensor numbers to the sensors
in an already running IQ S
ENSOR N ET system.
Note
When the inactive datasets are deleted, all settings for the sensors are
deleted as well.
1 Unplug all sensors from the IQ S ENSOR N ET .
2 Delete all inactive datasets in the list of sensors (see System
operating manual, chapter Deleting inactive datasets of
sensors).
3 Connect the sensors to the system in the required order. For
each sensor, wait until the sensor is recognized by the system
(see System operating manual, chapter Installation).