YSI IQ SensorNet MIQ/JBR Module - Manual (Page 9)

MIQ/JBR Installation
3 - 1 ba76077d01 01/2012
3 Installation
3.1 Scope of delivery
The scope of delivery of the MIQ/JBR is listed in the I NSTALLATION
chapter of the system operating manual.
3.2 Assembly in the IQ S ENSOR N ET
General assembly
instructions
The IQ S ENSOR N ET provides a number of options for integrating the
MIQ/JBR mechanically and electrically in the system (stacked
mounting, distributed mounting, etc.). The various types of installation
are described in detail in the I
NSTALLATION chapter of the system
operating manual.
Terminal strip
Fig. 3-1 Terminal strip of the MIQ/JBR
On the terminal strip inside the enclosure, the MIQ/JBR has four
SENSORNET connections. Two of these connections are assigned to
each of the signal ranges (section A, section B) in the IQ S
ENSOR N ET .
Outside contacts The outside contacts on the back and front side of the module
enclosure are connected with section A. Thus, all modules connected
to the MIQ/JBR by stack mounting are connected to section A.
A module can only be connected to section B via the 2 SENSORNET
connections for section B on the terminal strip.
X6 X6 X5 X5 X4 X4
SENSORNET 2 SENSORNET 4
RED RO
T
RED RO
T
SHIELD SCHIRM SHIELD SCHIRM GREEN GRÜN GREEN GRÜN
X3 X3 X2 X2 X1 X1
SENSORNET 1 SENSORNET 3
RED RO
T
RED RO
T
SHIELD SCHIRM SHIELD SCHIRM GREEN GRÜN GREEN GRÜN
ON
EIN
OFF
AUS
SN
TERMINA
TO
R
ON
EIN
OFF
AUS
SN
TERMINA
TO
R
SECTION B SECTION A