Create factory default image cd, Re-install bundled software without cd – Acer Aspire 5100 User Manual
Page 92
78
English
Create factory default image CD
When the System CD and Recovery CD are not available, you can create them by
using this feature.
1
Boot to Windows XP.
2
Press
3
Enter the password to proceed. The default password is six zeros.
4
In the Acer eRecovery Management window, select Recovery settings and
click Next.
5
In the Recovery settings window, select Burn image to disk and click Next.
6
In the Burn image to disk window, select 1. Factory default image or
2. Application CD and click Next.
7
Follow the instructions on screen to complete the process.
Note: Select 1. Factory default image when you want to burn a
bootable disk that contains your computer's entire operating
system as it was delivered to you from the factory. If you wish to
have a disk that will allow you to browse the contents and install
selected drivers and applications, select 2. Application CD — this
disk will not be bootable.
Re-install bundled software without CD
Acer eRecovery Management stores pre-loaded software internally for easy
driver and application re-installation.
1
Boot to Windows XP.
2
Press
3
Enter the password to proceed. The default password is six zeros.
4
In the Acer eRecovery Management window, select Recovery actions and
click Next.
5
In the Recovery settings window, select Reinstall applications/drivers and
click Next.
6
Select the desired driver/application and follow the instructions on screen
to re-install.
At first launch, Acer eRecovery Management prepares all the needed software
and may take few seconds to bring up the software content window.