AVSL Citronic CL22 - Manual (Page 2)

Introduction:
Thank you for choosing this Citronic compressor-limiter. This product has been designed to give accurate dynamics control to a
wide range of audio systems. In order to achieve the best results from this equipment and avoid damage through misuse, please
read and follow these instructions and retain for future reference.
Warning:
To prevent the risk of fire or electric shock, do not expose any part of the unit to rain or moisture.
If liquids are spilled on the surface, stop using immediately, allow unit to dry out and have checked by qualified personnel before
further use.
Avoid impact, extreme pressure or heavy vibration to the unit.
There are no user serviceable parts inside the compressor-limiter
– refer all servicing to qualified service personnel.
Safety

Check that the supplied mains lead is in good condition and the supply voltage is correct.

Ensure signal leads are of good condition and connected to appropriate inputs/outputs

Do not allow any foreign particles to enter the unit through control apertures or connector apertures
Placement

Keep out of direct sunlight and away from heat sources.

Keep away from damp or dusty environments.

When rack-mounting, avoid placing heavy units above the unit and ensure all connectors and controls are accessible
Cleaning

Use a soft cloth with a neutral detergent to clean the casing as required

Use a soft brush to clear debris from the control surface

Do not use strong solvents for cleaning the unit.
Front Panel
Rear Panel
1. EXPANDER/GATE indicator
2. EXPANDER/GATE THRESHOLD control
3. Gain reduction indicator
4. COMPRESSOR THRESHOLD control
5. COMPRESSOR RATIO control
6. COMPRESSOR ATTACK control
7. COMPRESSOR AUTO attack/release switch
8. LEVEL indicator
9. COMPRESSOR RELEASE control
10. COMPRESSOR OUTPUT level control
11. COMPRESSOR IN/OUT switch
12. ENHANCER PROCESS level control
13. Dual Mono/Stereo Link MODE switch
14. POWER switch
15. Voltage selector
16. IEC mains inlet
17. DETECTOR LOOP insert jack: Channel B
18. OUTPUT XLR: Channel B
19. OPERATING LEVEL switch: Channel B
20. INPUT jack: Channel B 21. INPUT XLR: Channel B
22. OUTPUT XLR: Channel A
23. DETECTOR LOOP insert jack: Channel A
24. OPERATING LEVEL switch: Channel A
15. INPUT XLR: Channel A
16. INPUT jack: Channel A