AVSL Citronic RU26H - Manual (Page 3)

171.860 User Manual
Control Layout
Setting Up
Insert the supplied AA batteries into the handheld transmitters by carefully unscrewing the base to
reveal the battery compartment inside the microphone body, connect the batteries (ensure + and -
are the correct way round for each cell) and carefully screw the base back on.
The antennae may be connected directly to the TNC connectors on the rear panel or alternatively
front-mounted (see below)
If the receiver is to be rack-mounted, unscrew the 2 front screws at each side of the case and use
these to secure the rack ears provided. These rack ears have apertures for front-mounting the
antennae if preferred and 2 TNC extension leads which should be connected from the TNC plug to
the rear panel TNC connectors and attached (using the threaded collars) to the apertures in the rack
ears, creating 2 sockets for the antennae to connect onto.
Turn microphone levels down on the receiver.
A choice of mixed output of both microphones on 6.3mm jack or individual balanced XLR outputs is
available on the rear panel of the receiver. Connect jack or XLR (optional) leads to the relative output
connector(s), turn down the volume of any equipment (mixer, amplifier etc.) that the signal will be
fed into and then connect the jack or XLRs to the equipment.
1. Backlit LCD display
2. Frequency Up button
3. Frequency Down button
4. Infra Red Frequency Set button
5. Channel Volume rotary control
6. Power button
7. Antenna front mounting aperture
8. Backlit transmitter display
9. Off – Mute – On switch
10. Battery compartment