AVSL 952.710-952.717 BC SERIES - Manual (Page 2)

BCV-series User Manual
Connection
BCV-series speakers are connected via 2 spring terminals at the rear of the
enclosure. For 100V operation, use double insulated cable rated to the total
maximum current, calculated as total max tapped power divided by 100V.
With the amplifier switched off, strip the speaker wire ends and connect
100V or “+” wire to the red terminal and connect Common or “-” to the
black terminal. Each model has a 100V transformer built in with various
volume settings or “tappings” available via a rotary switch at the rear
(BC6V example shown).
When used with a 100V line amplifier, select the required maximum
wattage that the speaker should demand from the amplifier. Ensure that
the sum of the wattages of all the speakers attached to the amplifier does
not exceed the recommended output of the amplifier.
When used with a standard (non-100V) amplifier, select the “8Ω” setting and refer to the amplifier
manufacturer’s manual to ensure that total speaker impedance (Ω) is not less than recommended for the
amplifier. It is imperative that the amplifier does not deliver more power than can be handled by the BCV
speaker. Refer to the amplifier manual and specifications below to calculate this. Normally, it is
recommended that the amplifier is capable of the RMS power rating of the speaker but cannot ever
exceed the Max power rating.
Specifications
Model BC3V BC4V BC5V BC6V
Woofer 75mmØ (3“) 100mmØ (4”) 130mmØ (5.25”) 165mmØ (6.5”)
Tweeter 50mmØ (2“) 25mmØ (1”) 25mmØ (1”) 25mmØ (1”)
Freq response 120Hz - 20kHz 110Hz - 20kHz 100Hz - 20kHz 90Hz - 20kHz
Power max : 8Ω 60W 70W 90W 120W
Power rms : 8Ω 30W 35W 45W 60W
Tappings 1.5/3/6W, 8Ω 2.5/5/10/20W, 8Ω 5/10/20/30W, 8Ω 5/10/20/40W, 8Ω
Dimensions (mm) 106 x 153 x 106 150 x 195 x 150 180 x 240 x 180 220 x 280 x 220
Weight 900g 1.63kg 2.38kg 3.08kg
SPL @ 1W/1m 88dB 88dB 88dB 89dB
Caution
The BCV-series speakers are intended for indoor use. Avoid moist or dusty environments.
Avoid excess heat and exposure to direct sunlight.
Take care not to overload speakers. HF drivers are especially prone to damage through overload.
For 100V installation, take proper care to insulate any contacts within reach of users.