AVSL 170.254-170.266 CT SERIES ACTIVE - Manual (Page 2)

CT Active Speakers User Manual
Introduction
Thank you for choosing the Citronic CT-series active speakers as part of your sound reinforcement system. These high output cabinets are designed to
offer high quality, dependable service for mobile and installed systems. Please read this manual fully and follow the instructions to achieve the best
results with your new purchase and to avoid damage through misuse.
Warning
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on the casing, stop using immediately, allow unit to dry out and have checked by qualified personnel before further use. Avoid
impact or extreme pressure to the case
No user serviceable parts inside – Do not open the case – refer all servicing to qualified service personnel.
Safety
 Check for correct mains voltage and condition of IEC lead before connecting to power outlet
 Ensure signal leads are good condition with no short connections or damaged plugs
Placement
 Position on a stable surface or pole mount stand. If suspended by flying points, ensure fixings are adequate for the weight load.
 Keep away from heat sources and away from damp or dusty environments
 Ensure adequate access to controls and connections
Cleaning
 Use a soft dry or slightly damp to clean the cabinet as required
 Do not use strong solvents for cleaning the unit
Amplifier Panel
1. HI CUT control (170.266 only)
Adjusts cutoff frequency of sub filter
2. INV switch (170.266 only)
Polarity invert function
3. BASS control (not 170.266)
Adjusts low frequency level
4. TREBLE control (not 170.266)
Adjusts high frequency level
5. VOLUME control
Adjusts overall output level
6. OUTPUT XLR
Signal output (balanced)
7. INPUT XLR
Signal input (balanced)
8. MIC/LINE switch (not 170.266)
Selects Mic or Line level for input
9. MAINS inlet and power switch
Combined IEC inlet, fuse holder and
power switch