AVSL 160.465 FH-1500 User Manual
Page 3
160.465UK User Manual
Rear Panel
Setting up
The FH-1500 requires haze fluid to create the effect.
It is recommended to use one from the range of qtx haze fluids for best results.
A chart for recommended fluids is included further along in this document.
Unscrew the top cap of the haze fluid tank and remove to fill with the selected haze fluid
Replace the cap and close securely, ensuring the pipe is fed down to the bottom of the bottle so that a
consistent flow of fluid is supplied to the machine
Connect the remote timer control to the 5-pin XLR connector on the rear panel (2)
Connect the supplied wireless remote receiver to the 5-pin DIN connector (1) on the rear panel
Set the FAN SPEED rotary control (6) to maximum to start with
Connect the IEC mains lead supplied to the rear mains inlet (8)
If controlling via DMX, connect the incoming DMX control signal via the 3-pin XLR labelled DMX IN (3)
Connect any further DMX equipment to the XLR labelled DMX OUT (4)
Set the DMX start address using the rear panel DIP switches (5) in binary number format
Examples are shown below…
1.
Wireless remote receiver connection (5-pin DIN) 5.
DMX channel setting DIP switches
2.
Remote timer control connection (5-pin XLR)
6.
Fan speed rotary control
3.
DMX in connection (3-pin XLR)
7.
Mains power on/off rocker switch
4.
DMX out connection (3-pin XLR)
8.
Mains inlet (IEC male) and fuse holder