AVSL 160.459 HZ-3 User Manual
Page 4
160.459UK User Manual
SETUP:
1.
Unpack the haze machine
2.
Unscrew the top cap of the tank and remove to fill with the recommended
haze fluid
3.
Replace the bottle and screw the cap securely ensuring the pipe is fed down to
the bottom of the bottle so a consistent flow of fluid is supplied to the machine
4.
Connect the remote control
5.
Connect the IEC mains plug and power up
6.
Heat up time is usually between 2-3 minutes. Please ensure no button is
pressed during the heat up time. When the machine is ready the LED light on
the machine and remote control will illuminate
7.
After heat up, please refer to page 8 “Operation for HZ-3”
CAUTION! TO PREVENT MORTAL ELECTRICAL RISK AND LONG LIFE OPERATION:
For your safety, please kindly pay attention to all of the warnings listed below:
Always plug in the power plug last and disconnect from the mains when the
device is not in use or before cleaning
Do not install and operate the device in rain or extreme heat, moisture or dusty
environments
This device is for indoor use only and in a dry environment
Do not switch on immediately but wait until it reaches to room temperature if
the device has been exposed to drastic temperature fluctuations
Do not shake the device and avoid brute force when installing or operating
Do not use the device during thunderstorms and please disconnect the power
Do not use solvents or aggressive detergent to clean the device. Use a soft and
clean cloth
Do not modify the device or the connected power cord without authorisation