AVSL 160.458 FH-700 - Manual (Page 5)

160.458UK User Manual
CONNECT WITH POWER SUPPLY – THE GROUND WIRE MUST BE CONNECTED:
Use the plug to connect to the main power supply as follows:
Wire Connection International signal
Brown Live L
Blue Neutral N
Yellow /Cyan Earth
QUICK TROUBLE SHOOTING
If the unit is not functioning properly

Check if main power is on.
 Check the fuse hasn’t blown.
 Check the unit isn’t in DMX mode.
 Check there is fluid in the tank and the pipe is pushed down to the bottom of the bottle
 If there is blockage use distilled water or haze machine cleaning fluid
REPLACING FUSE
Disconnect from the main power supply first. Then remove the fuse holder above the IEC
Socket to reveal the fuse. Replace the correct fuse rating as stated on lighting or user guide.
Then, lock the fuse holder cover back into place.
GENERAL MAINTENANCE
To maintain optimum performance and minimize wear, the item should be cleaned frequently.
Usage and environment are contributing factors in determining frequency. As a general rule,
fixtures should be cleaned after use to avoid dust build-up and blockages, which can result in
poor performances, overheating and breakages. Be sure to power off fixture before conducting
maintenance.
Unplug fixture from power. Use a vacuum or air compressor and a soft brush to remove dust
collected on external vents and internal components. Clean the external case when the fixture
is cold with a dry cloth or tissue, and drag dirt and grime to the outside case.