AVSL 153.770 ILA2 - Manual (Page 6)

Remote control
1. POWER LED on / standby button
2. LIGHT switches from pattern to static light mode
3. 100% sets static light brightness to 100%
4. MODE+ steps upwards through modes
5. SPEED- reduces speed of pattern
6. MODE- steps downwards through modes
7. BRIGHT+ increases brightness
8. BRIGHT- decreases brightness
9. 50% sets static light brightness to 50%
10. 25% sets static light brightness to 25%
11. SPEED+ increases speed of pattern
 Remove the clear tab from the handheld remote to engage the battery (replacement CR2025 button cell)
 To switch LEDs on, press the POWER button (from standby, the last setting is resumed)
 If there is no response from the handset, it may be necessary to pair the handset to the controller (see “Pairing” below)
 MODE+ and - buttons step through the 8 preset programmes in sequence (shown below)
 SPEED+ or - will alter the rate of change in the selected mode
 LIGHT button overrides the pattern mode to give a static light setting
 BRIGHT+ or - will change the brightness in static mode
 Preset brightness can be jumped to via the 25%, 50% or 100% buttons
 Press POWER to enter standby mode (all LEDs off)
Pairing: If the LED controller does not respond to the RF remote handset, disconnect DC power from the controller.
Reconnect the DC power to the controller and hold down the “100%” and “25%” buttons simultaneously.
The controller and handset should now be paired and the controller should respond to the handset.
Preset Name Description
1 Random Glow Fade in and out at random brightness & intervals
2 Regular Glow Fade between fully on and off at a regular rate
3 Half Glow Fade between fully on and half-on at a regular rate
4 Flicker Flash on and off at a fast regular rate
5 Offset Flash Flash on and off with pause at a regular rate
6 Even Flash Flash on and off evenly at a regular rate
7 SOS 3 short - 3 long - 3 short Morse Code flash sequence
8 Strobe Very short burst at regular intervals
Specifications
Power supply
5-24Vdc, 12A (50% duty cycle) or 6A (100% duty cycle)
Remote control frequency 433MHz
Lead length (power input, LED output) 100mm
Connections Red wire “+”, black wire “-”
Controller dimensions 42 x 13 x 5mm
Weight 4.8g