AVSL 154.096 DM-X4 - Manual (Page 2)

154.096UK User Manual
Introduction
Thank you for choosing the DM-X4 mini DMX PAR controller as part of your lighting control system.
This unit is designed to control DMX PAR fixtures with RGB or RGBW colour mixing.
Please read these instructions to gain the best results from this item and avoid damage through misuse.
Unpacking
Your DM-X4 should reach you in good condition and should be supplied with an appropriate mains adaptor.
If there are any signs of damage or items missing from the packaging, contact your dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose any components to rain or moisture.
Avoid any impact or extreme pressure to the housing or control surface.
No user serviceable parts inside - do not open the case. Refer all servicing to qualified service personnel.
Placement
The DM-X4 may be free standing on a stable surface or wall mounted by either hanging on screws with the
rear punch-holes or flush-mounting with the 4 front mounting holes.
Safety
 Check for correct mains voltage before connecting the D.C. adaptor
 Ensure DMX leads are good condition with no short connections or damaged plugs
Cleaning
 Use a soft dry or slightly damp cloth to clean the casing. Do not use strong solvents
 Periodically clear any debris from fader slots with a soft brush
Panel Layouts
1. RGBW channel faders
2. Group buttons
3. Channel Mode button & indicators
4. Run Mode button
5. Blackout button
6. Strobe button
7. Mix fader
8. MAC slider
9. Speed control
10. Strobe Speed/Sound Sensitivity slider
11. DMX out XLR
12. D.C. input jack
13. Power switch