AVSL 160.471 QTFX-F2 - Manual (Page 2)

160.470UK, 160.471UK User Manual
Introduction
Really heat up your party with this mesmerising flame effect.
Reaching up to a height of 1.5m, the silk flame flutters in the air whilst lit up with a
combination of 10mmØ LEDs, giving the appearance of a hot flame.
Offering low maintenance and quick set up, it is perfect for event and hire companies
or as a permanent fixture on stage.
· Reaches up to a height of 1.5m
· Red and blue 10mmØ LED (QTFX-F1)
· RGB Colour mixing (QTFX-F2)
· High speed fans
· Replacement silk flames available (Ref: 160.472UK)
Caution
· Always plug in the power plug last and disconnect from the mains when the
device is not in use or before cleaning
· Do not install the device in extreme heat, moisture or dusty environments
· Ensure that the unit has reached room temperature before switching on power
· Avoid heavy vibration or impact to the housing
· Do not use solvents or aggressive detergent to clean the device
· Do not modify the device or the supplied mains lead
· This product must be earthed. Please follow the wiring shown below…
Brown Live L
Blue Neutral N
Yellow /Cyan Earth / Ground
Replacing the fuse
Disconnect from the main power supply first, then remove the fuse holder above the IEC
Socket to reveal the fuse. Replace the correct fuse rating as stated on lighting or user guide.
Then, lock the fuse holder cover back into place.
General maintenance
To maintain optimum performance and minimize wear, the item should be cleaned frequently
to avoid dust build-up and blockages, which can result in poor performance or damage
Be sure to power off fixture before any maintenance
Unplug fixture from power. Use a vacuum or air compressor and a soft brush to remove dust
collected on external vents and internal components
Clean the external case when the fixture is cold with a dry cloth or tissue