Arnott remanufactured rear left abc strut for, Mercedes-benz s-class (amg), Mercedes-benz cl-class (amg) – Air Suspension SK-2461 REV 2 User Manual
Page 2
2
REV 2
02/12/2013
SK-2461
SK-
2461
ARNOTT REMANUFACTURED
REAR LEFT ABC STRUT FOR
2002-2006
MERCEDES-BENZ S-CLASS (AMG)
2002-2006
MERCEDES-BENZ CL-CLASS (AMG)
ABC STRUT REMOVAL
1.
REMOVE THE STRUT COVER LOCATED ON THE REAR DECK.
2.
DISCONNECT THE ELECTRICAL CONNECTOR AND REMOVE THE THREE (3) NUTS ON THE TOP OF THE
STRUT.
(FIGURE A)
3.
SET STEERING TO STRAIGHT AHEAD.
4.
RAISE VEHICLE.
5.
REMOVE REAR WHEEL.
Consult your vehicles owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
FIGURE A
GENERAL INFORMATION:
Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement,
the full text of which is available at www.arnottinc.com.
• Not to be stored below 5
o
F (-15
o
C) and above 122
o
F (50
o
C).
• Avoid damage to hydraulic lines and cables.
• Removal and installation is only to be performed by fully qualified personnel.
• Use car manufacturer’s diagnostic software.
CAUTION:
Work is to be performed by a factory trained mechanic; failure to do so may cause damage to the vehicle. Diagnostic
software is required to re-pressurize the hydraulic system after strut installation.