AIPTEK PocketCinema V60 - Manual (Page 18)

User’s Manual
Page 18
EN
Notice for Long-time Projection
The built-in battery supports approximately 100 mins of projection. For long time
projection, you are recommened to use AC adapter.
When the battery is too weak to stay in operation, the low battery capacity icon (
)
will flash. You need to charge the product while the icon showed.
It’s normal that the projector will feel warm with continuous use due to its high
performance. If the projector runs for a long time and over-heated, the
High-Temperature icon (
) will appear on the screen. The system will automatically
enter the standby mode.
Troubleshooting
If your projector does not seem to be functioning properly, check the items below before
you contact an authorized service center.
Reset Your Device
Occasionally, you may need to reset your Micro
Projector.
This can be useful when a program is not performing
properly. Push the Power switch downward for 10
seconds to RESET your device.
Symptom Check Point
The projector does not
work when connecting
to a notebook PC. 1. Check if the HDMI cable is plugged correctly.
2. Make sure the PC has been switched to projector
display.
The projected image is
too dark. 1. Use the projector in a darker environment.
2. Increase the brightness by using the AC power
adapter.
3. Scale down the projectional image size.
The projected image is
blur. 1. Adjust the focus. Please refer to “Adjusting the Focus”.
2. Check if the protection film is removed. Or, check if the
lens is dirty.
The surface
temperature of projector
is high. Because of the high-luminance LED, it is normal that this
projector generates heat in long-time use. It will not affect
the performance of the projector. Always keep the
ventilation slots free of dirt or obstructions and operate the
projector in a properly ventilated environment.