Asus M2E User Manual

Page 15

Configuring the BIOS

System Password [Enter]

The system password protects the BIOS settings. When “Enabled”, you will be prompted for a pass-
word after you press [F2] to enter BIOS setup.

To Enable: Select “Enter” and press [Enter], type a password and press [Enter], type the same pass-
word again and press [Enter] to confirm. (You can type up to eight alphanumeric characters. Symbols
and other keys are ignored.)

To Disable: Select “Set” and press [Enter] without entering a password.

Hard Disk Password [Enter]

A hard disk password places a protection on the hard disk drive so that a password is necessary in order
to access the hard disk drive. When “Enabled”, the hard disk drive will be protected as follows:

• The protected hard disk drive will prompt for a password when accessed on the Notebook PC.

• The protected hard disk drive cannot be used as a master or slave drive on another computer.

• The protected hard disk drive cannot be formatted.

To Disable: Select “Set” and press [Enter], enter the password and press [Enter].

NOTE: If “Password on Boot” and “Hard Disk Password” are both “Enabled”, the “Hard Disk Pass-
word” will be required first.