Iv. bios software, Updating your motherboard's bios – Asus P/I-P6NP5 User Manual
Page 34
P/I-P6NP5 User's Manual
28
IV. BIOS SOFTWARE
IV
. BIOS
(Flash Memory W
riter)
Updating your Motherboard's BIOS
1. Download an updated BIOS file from a Bulletin Board Service (BBS) or the
internet (WWW) and save to the diskette you created in step 1 of the Main
Menu. Visit ASUS WWW at http://www.asus.com.tw/ or FTP: ftp.asus.com.tw/
pub/ASUS or see ASUS CONTACT INFORMATION on page II.
2. Turn off your computer and open the system cabinet to Enable "Boot Block
Programming" jumper as shown in section III.
2. Boot from the floppy diskette you created in step 1 of the Main Menu.
3. At the "A:\" prompt, type: PFLASH
4. Enter "2" from the Main Menu or "2" from the Advanced Features Menu.
You will be prompted with the following if “Advanced Features” is necessary.
Boot Block of New BIOS is different from old one !!!
Please Use 'Advanced Feature' to flash whole bios !!!
5. The program displays a second screen prompting you for the name of the BIOS
file. Type in the complete name of the file, including the file name extension,
and then press the
disk. The following message will appear:
DO NOT TURN OFF THE SYSTEM IF THERE IS A PROBLEM!
If you encounter problems while downloading the new BIOS, DO NOT turn off
your system since this might prevent your system from booting up. Just repeat
the process, and if the problem still persists, upload the original BIOS file you
saved to disk in step 1 of the Main Menu.
WARNING: If the Flash Memory Writer utility was not able to successfully
download a complete BIOS file, your system may not be able to boot up. If
this happens, your system will require service from your vendor.
6. After successfully downloading the new BIOS file, exit the Flash Memory Writer
utility and then turn off your system. Set the jumper back to its default setting
of Programming “Disabled.”
7. Turn on your computer and hold down
select "Setup Default" to affect the new BIOS, then you may set other items
from the Main Menu.