Asus P/I-P6NP5 - Manual (Page 13)

P/I-P6NP5 User's Manual 7
III. INSTALLATION
Jumper Settings
1. On-Board Multi-I/O Selection (JP10)
You can disable the onboard Multi-I/O (floppy, serial, parallel, and IrDA)
through BIOS or entirely with the following jumper in order to use your
own Multi-I/O card.
Selections JP10
Enable [1-2] (Default)
Disable [2-3]
1
Multi I/O Setting (Enable / Disable)
2
3
Enable (Default) Disabled
JP10 JP10
2. Flash ROM Boot Block Programming (JP13)
This sets the operation mode of the boot block area of the BIOS Flash
ROM to allow programming in the Enabled position.
Programming JP13
Enabled [2-3] (Default)
Disabled [1-2]
Boot Block Programming (Disable / Enable)
Enable (Default)
JP13
1
2
3
JP13
Disabled
III. INST
ALLA
TION
(Jumpers)