Asus M2N-SLI - Manual (Page 52)

2-32 Chapter 2: Hardware information
12. System panel connector (20-pin PANEL)
This connector supports several chassis-mounted functions.
• System power LED (2-pin PLED)
This 2-pin connector is for the system power LED. Connect the chassis
power LED cable to this connector. The system power LED lights up when
you turn on the system power, and blinks when the system is in sleep mode.
• Hard disk drive activity LED (2-pin IDE_LED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity
LED cable to this connector. The IDE LED lights up or flashes when data is
read from or written to the HDD.
• System warning speaker (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
• ATX power button/soft-off button (2-pin PWRSW)
This connector is for the system power button. Pressing the power button
turns the system on or puts the system in sleep or soft-off mode depending
on the BIOS settings. Pressing the power switch for more than four seconds
while the system is ON turns the system OFF.
• Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system
reboot without turning off the system power.
R
M2N-SLI
M2N-SLI System Panel Connector
* Requires an ATX power supply
NEL
PLED-
PWR
+5V
Speaker Ground
RESE
T
Ground
Reset
Ground
Ground
PWRS
W
PLED+
IDE_LED-
IDE_LED+ IDE_LE
D
PLED
SPEAKER
PA