Asus M2N-SLI - Manual (Page 101)

ASUS M2N-SLI 4-41
The items Typematic Rate (Chars/Sec) and Typematic Delay (Msec) becomes
user-configurable only when the item Typematic Rate Setting is enabled.
Boot Up Floppy Seek [Disabled]
Enable this item to check for a boot floppy disk during POST.
Configuration options: [Disabled] [Enabled]
Bootup Num-Lock [On]
Allows you to select the power-on state for the NumLock.
Configuration options: [Off] [On]
Typematic Rate Setting [Disabled]
Allows you to set the keystroke rate. Enable this item to configure the Typematic
Rate (Chars/Sec) and the Typematic Delay (Msec). Configuration options:
[Disabled] [Enabled]
Typematic Rate (Chars/Sec) [6]
Allows you to select the rate at which a character repeats when you hold a key.
Configuration options: [6] [8] [10] [12] [15] [20] [24] [30]
Typematic Delay (Msec) [250]
Allows you to set the delay before keystrokes begin to repeat. Configuration
options: [250] [500] [750] [1000]
OS Select for DRAM > 64MB [Non-OS2]
Set this item to OS2 only when you are running on an OS/2 operating system with
an installed RAM of greater than 64 KB. Configuration options:
[Non-OS2] [OS2]
Full Screen LOGO [Enabled]
Allows you to enable or disable the full screen logo display feature. Configuration
options: [Disabled] [Enabled]
• Make sure that the above item is set to [Enabled] if you want to use the
ASUS MyLogo2™ feature.
• See section “5.4.1 ASUS MyLogo2™” for details.
Halt On [All, But Keyboard]
Allows you to error report type.
Configuration options: [All Errors] [No Errors] [All, But Keyboard] [All, But
Diskette] [All, But Disk/Key]