Asus TS100-E6/PI4 - Manual (Page 138)

6-14 Chapter 6: Driver installation
7. When asked if you will load additional RAID controller drivers, select No, then
press .
6. Insert the Red Hat ® Enterprise RAID driver disk to the floppy disk drive, select
OK, then press .
The drivers for the RAID card are installed to the system.
Insert Driver Disk
Insert your driver disk into /dev/fd0
and press “OK” to continue.
OK Back
8. Follow the onscreen instructions to finish the OS installation.
9. If you install RHEL AS5, when the installation is completed, DO NOT click
Reboot. Press + + to switch to the command-line interface
from graphic user interface.
More Driver Disks?
Do you wish to load any more
driver disks?
Yes No
10. Type the following commands when using a USB floppy.
cat /proc/partitions
Write down the Major and Minor number before sdb for later use.
mknod /dev/sdb b [major number] [minor number]
mkdir /mnt/driver
mount /dev/sdb /mnt/driver
cd /mnt/driver
sh replace_ahci.sh
reboot