Asus Z8NA-D6 - Manual (Page 130)

5-28 Chapter 5: RAID configuration
2. Enter a name for the recovery set and press .
3. When the
RAID Level item is selected, press the up/down arrow key to select
Recovery, and then press .
4. When the Disks item is selected, press to select the hard disk drives
you want to include in the recovery set. The SELECT DISKS screen appears.
5. Use the up/down arrow key to select a drive, press to select a Master
disk, and then press to select a Recovery disk. A small triangle
marks the selected drive. Press after completing your selection.
6. When the Sync item is selected, use the up/down arrow key to select a sync
option that you want and press .
7. When the Create Volume item is selected, press . The following
warning message appears.
[ SELECT DISKS ]
Port Drive Model Serial # Size Status
0 ST3160812AS 9LS0HJA4 149.0GB Non-RAID Disk
1 ST3160812AS 9LS0F4HL 149.0GB Non-RAID Disk
2 ST3160812AS 3LS0JYL8 149.0GB Non-RAID Disk
3 ST3160812AS 9LS0BJ5H 149.0GB Non-RAID Disk
Select 1 Master and 1 Recovery disk to create volume.
[↑↓]-Prev/Next [TAB]-(M)aster [SPACE]-(R)ecovery [ENTER]-Done
WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST.
Are you sure you want to create this volume? (Y/N):
8. Press to create the recovery set and return to the main menu, or to
go back to the CREATE VOLUME menu.
If a recovery set is created, you cannot add more RAID sets even when you
have more non-RAID disks installed in your system.