Asus ASMB3 - Manual (Page 27)

ASUS ASMB3-SOL 2-13
ASMC Help Menu options
2.5.1 Configuring the LAN controller
Before you can establish connection to the ASMB3-SOL board, you must configure
the LAN port for server management used by the remote server to connect to the
local/central server.
To configure the LAN port of the remote server:
1. On the prompt, type asmc -init_asmb, then press . The screen
displays the auto-detected information including the system/motherboard
name, and the IPMI2.0 interface. The screen also shows the status of the
ASMB3-SOL.
2. Shut down the remote server, then disconnect the power plug from the
electrical socket to initialize the ASMB3-SOL.
3. Restart the remote server from the support CD.
4. Run the ASMC utility from the support CD following the instructions in the
previous section.
Options Description
-flash -load filename Update the ASMB3-SOL firmware
-sdr -save filename Save the SDR data to file
-sdr -load filename Update the SDR data from file
-kcs[smic/bt/pci_smic] NetFn command data.... Send IPMI command
-bmc_ip [ip_addr]
(e.g., bmc_ip 10.10.10.20)
Write the BMC IP address
--pet_ip_mac [ip_addr] [mac_addr]
(e.g., pet_ip_mac 10.10.10.20 010203040506)
Write the PET destination IP and MAC
addresses
-adm_name new_name_string Change the administration name
-user_name new_name_string Change the user name
-adm_password new_adm_password Change the administration password
-user_password new_user_password Change the user password
-init_asmb Initialize ASMB3-SOL
-sol_baud [baud rate]
(e.g., sol_baud 57600)
Set the communication Baud rate
-bmc_info Displays the BMC and PET IP and
MAC addresses
c:\dos>asmc -init_asmb
Detect System -> DSBF-D/SAS
Detect Motherboard -> (DSBF-D/SAS)
Detect KCS Interface
Initial BMC O.K.