Asus VG23AH - Manual (Page 18)

3-4 Chapter 3: OSD (On-Screen Display) Menu
• Sharpness: Adjust the picture sharpness. The adjusting range
is from 0 to 100.
• Trace Free: Speed up the response time. The adjusting range is
from 0 to 100.
• Aspect Control: Adjust the aspect ratio to “4:3”, “Full”, or
“ OverScan”. (The “OverScan” ratio is only available for HDMI
input.)
• ASCR: Turn on or off the ASCR (ASUS Smart Contrast Ratio)
function. (Only available at Scenery, Theater, Game, and Night
View Mode.)
• 3D Mode Selection: Select the type for 3D images.
•
Default: Turn “2D to 3D” function off.
• 2D to 3D: Turn “2D to 3D” function on for 2D input images
(you may also press the hotkey to access this
function).
• 3D Top-and-Bottom, 3D Side-by-Side (Half): Select the
type for incoming 3D images.
• The menu “ 3D Mode Selection” is only available for input source of 2D type.
• The menu “3D Top-and-Bottom” and “3D Side-by-Side (Half)” are only
available for HDMI source of 720p/1080i/1080p timing and no InfoFrame of
3D type.
• 3D Depth: Adjust the field depth for 3D images. The adjusting
range is from 1 to 10.
• Position: Adjust the horizontal position (H-Position) and the
vertical position (V-Position) of the image. The adjusting range is
from 0 to 100. (Only available for VGA input.)
• Focus: Reduce Horizontal-line noise and Vertical-line noise
of the image by adjusting (Phase) and (Clock) separately. The
adjusting range is from 0 to 100. (Only available for VGA input.)
• Phase adjusts the phase of the pixel clock signal. With a wrong phase
adjustment, the screen shows horizontal disturbances.
• Clock (pixel frequency) controls the number of pixels scanned by one
horizontal sweep. If the frequency is not correct, the screen shows vertical
stripes and the image is not proportional.