AEG S71709TSW0 - Manual (Page 32)

2
1
• Unscrew the top door hinge pin of the
appliance then screw it back on the
other side.
• Remove the lower hinge. Put over the
pin in the direction of the arrow.
• Fit the appliance door on the upper
door hinge pin.
• Unscrew and install the screw on the
opposite side.
• Install the lower hinge on the opposite
side leaving the position of the door
unchanged.
• Screw in the one screw in the place set
free on the other side as well as the
right foot.
1
2
3
4
• Remove and install the handle (if fore-
seen) on the opposite side.
• Reposition, level the appliance, wait
for at least four hours and then con-
nect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact
the nearest After Sales Service Force.
The After Sales Service specialist will car-
ry out the reversibility of the doors at
your cost.
9.8 Plug socket
CAUTION!
Make sure that the mains cable
can move freely.
The plug socket necessary for connec-
tion of your appliance to the electricity
supply should be positioned so that it is
possible to pull out the appliance plug.
If your appliance is installed under a con-
tinuous worktop, the plug socket should
be provided as shown.
32 www.aeg.com