AEG S71709TSW0 - Manual (Page 31)

9.6 Fitting and mounting to continuous worktop
Before fitting, change the door opening
direction if necessary (see: Door reversi-
bility).
• Push the appliance carefully into the
niche.
• Take care that the mains cable is not
jammed in.
• Check distance from wall (see: Instal-
ling under a continuous worktop).
• Level the appliance by screwing the
two adjustable feet at the front in or
out, thus ensuring a stable position.
• With a suitable screws (depending on
the design of the worktop and the dis-
tance between the appliance and the
worktop, not supplied), fix the appli-
ance under the worktop through the
upper door hinge. If necessary, equal-
ize the gap between the door hinge
and the worktop with a suitable wash-
er (plastic or wood, not supplied). This
will prevent bending of the hinge and
possible failure of door function.
9.7 Door reversibility
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power
socket.
• Tilt back the appliance carefully so
that the compressor cannot touch the
floor.
• Unscrew the left foot.
• Unscrew the screws of the door bot-
tom hinge.
• Take off the appliance door by pulling
it slightly downwards.
ENGLISH
31