Asus AP1600R-E2(CS3) - Manual (Page 30)

C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p 2 - 1 2 2 - 1 2 2 - 1 2 2 - 1 2 2 - 1 2
8. Secure the riser card bracket to
the chassis with the screw that
you removed earlier.
9. Connect the cable(s) to the
card, if applicable.
6. Install the riser card bracket
with the card into the PCI-X slot
on the motherboard.
7. Make sure that the golden
connectors completely fit the
slot and the bracket aligns with
the rear panel.
5. Take note of the holes on the
riser card bay. The two pegs on
the riser card bracket should
match these holes to ensure
that the bracket is properly in
place.
P e g o n t h e r i s e r P e g o n t h e r i s e r P e g o n t h e r i s e r P e g o n t h e r i s e r P e g o n t h e r i s e r
c a r d b r a c k e t
c a r d b r a c k e t c a r d b r a c k e t c a r d b r a c k e t c a r d b r a c k e t