Asus M2NPV-VM - Manual (Page 41)

ASUS M2NPV-VM 1-29
1.10.2. Internal.connectors
1.. Floppy.disk.drive.connector.(34-1.pin.FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using an FDD cable with a covered Pin 5.
2. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
M2NPV-VM
®
M2NPV-VM.Floppy.disk.drive.connector
NOTE:.Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
FLOPPY
M2NPV-VM
®
M2NPV-VM Chassis intrusion connector
CHASSIS
+5VSB_M
B
Chassis Signal GND
(Default)