5 rear spacers, 6 removing the shelf holders – AEG S53400CSS0 User Manual
Page 35

8.5 Rear spacers
2
4
3
1
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1.
Release the screw.
2.
Engage the spacer below the screw.
3.
Turn the spacer to the right position.
4.
Tighten again the screws.
8.6 Removing the shelf holders
A
B
C
Your appliance is equipped with shelf re-
tainers that make it possible to secure
the shelves during transportation.
To remove them proceed as follows:
1.
Move the shelf holders in the direc-
tion of the arrow (A).
2.
Raise the shelf from the rear and
push it forward until it is freed (B).
3.
Remove the retainers (C).
ENGLISH
35
This manual is related to the following products:
See also other documents in the category AEG Refrigerators:
- SKZ71800F0 (24 pages)
- SKZ71800F0 (2 pages)
- SKZ71800F0 (20 pages)
- SCZ71800F0 (24 pages)
- SCZ71800F0 (28 pages)
- SCZ71800F0 (2 pages)
- SCN71800S0 (32 pages)
- SCS51800F0 (28 pages)
- SCS51800F0 (2 pages)
- SCS51800F0 (32 pages)
- SCS51800F0 (24 pages)
- SCS71800F0 (24 pages)
- SCS71800F0 (28 pages)
- SCS71800F0 (2 pages)
- SCS71800F0 (76 pages)
- SKS58240F0 (24 pages)
- SKS58240F0 (2 pages)
- S83200CMW0 (28 pages)
- S83200CMW0 (20 pages)
- S83200CMW0 (60 pages)
- S83200CMW0 (2 pages)
- S83200CMW0 (28 pages)
- S53630CSX2 (200 pages)
- S83600CMM0 (24 pages)
- S83600CMM0 (2 pages)
- S92500CNM0 (92 pages)
- S63300KDW0 (24 pages)
- S83600CSM1 (28 pages)
- SKS58200F0 (20 pages)
- SKS58200F0 (64 pages)
- SKS58800S1 (60 pages)
- SKS71200F0 (20 pages)
- SKS58200F0 (16 pages)
- AGS77200F0 (68 pages)
- SKD71800F0 (20 pages)
- SKD71800F0 (64 pages)
- SKD71800F0 (24 pages)
- SKD71800F0 (2 pages)
- SCS81800F0 (76 pages)
- SCS81800F0 (64 pages)
- SCS81800F0 (100 pages)
- SCS81800F0 (84 pages)
- SCS81800F0 (92 pages)
- S83200CMM0 (2 pages)
- S83200CMM0 (28 pages)