Asus AP140R - Manual (Page 43)

AP140R Server User’s Manual 43
The system continuously beeps
after it was turned on
1. Check the memory modules
and make sure you installed
the DIMMs the system
supports.
2. Make sure that the DIMMs are
properly installed on the
sockets.
The message “Non-system disk
or disk error” appears A primary logical partition must
be created and set active to
boot from it.
Network connection not
available 1. Make sure the network cable is
connector the RJ-45 port on
the rear panel.
2. Make sure that you have
installed the network drivers
from the motherboard support
CD.
Problem Action