Asus V9-P8H77E - Manual (Page 57)

3-5 ASUS V-P8H77E
2. Intel ® H77 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1/2 [gray])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• These connectors are set to [IDE] by default. If you intend to create a Serial ATA RAID
set using these connectors, set the SATA Mode Selection item in the BIOS to [RAID].
See section 4.4.3 SATA Configuration for details.
• Before creating a RAID set, refer to the RAID Supplementary Guide included in the
folder named Manual in the support DVD.
• You must install Windows ® XP Service Pack 3 or later version before using Serial ATA
hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is available only if
you are using Windows ® XP SP3 or later version.
• When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to
[AHCI]. See section 4.4.3 SATA Configuration for details.
SATA6G_2
G
N
D
R
S
A
TA
_R
X
P
2
R
S
A
TA
_R
X
N
2
G
N
D
R
S
A
TA
_TX
N
2
R
S
A
TA
_TX
P
2
G
N
D
SATA6G_1
G
N
D
R
S
A
TA
_R
X
P
1
R
S
A
TA
_R
X
N
1
G
N
D
R
S
A
TA
_TX
N
1
R
S
A
TA
_T
X
P
1
G
N
D P8H77-M PRO_DP
P8H77-M PRO_DP Intel ® SATA 6.0Gb/s connectors
3. Serial port connector (10-1 pin COM1)
This connector is for a serial (COM) port. Connect the serial port module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
The COM module is purchased separately.
P8H77-M PRO_DP
P8H77-M PRO_DP Serial port (COM1) connector
PIN 1
COM1
D
C
D
TX
D
G
N
D
R
TS R
I
R
X
D
D
TR
D
S
R
C
TS