Asus AW171 - Manual (Page 115)

ASUS SK8N motherboard 5-19
5.6 Creating a floppy disk with RAID driver
A floppy disk with the Promise ® SATA 378 or FastTrak 378 driver is
required when installing Windows ® XP™, Windows ® 2000™ or Windows ®
NT™ operating systems. You can create a floppy disk with the RAID driver
using the Makedisk.exe utility. A floppy disk with a RAID driver is
necessary when configuring RAID installations.
To create a floppy disk with RAID driver:
1. Insert the motherboard support CD into the CD-ROM drive and locate
the Makedisk.exe utility for your RAID controller.
A. The Promise ® SATA 378 driver is located in
“\Drivers\Promise\378ATA\Makedisk.exe” of the motherboard
support CD.
B. The Makedisk.exe utility for the FastTrak 378 driver is located in
“\Drivers\Promise\378RAID\Makedisk.exe” of the motherboard
support CD.
2. Insert a clean floppy disk into the floppy disk drive and execute
Makedisk.exe. Follow succeeding screen instructions.
3. Write-protect the floppy disk to avoid computer virus infection.
To use the floppy with RAID driver:
1. During Windows ® OS installation, the system prompts to press the F6
key to install third-party SCSI or RAID driver.
2. Insert the floppy disk with RAID driver into the floppy disk drive and
press F6.
3. Follow the succeeding screen instructions.
For additional information on RAID installation and configuration, refer
to the Promise
® RAID installation guide found in
“\Drivers\Promise\Setup” of the motherboard support CD.