Asus A8N-SLI - Manual (Page 48)

2 - 1 2 2 - 1 2 2 - 1 2 2 - 1 2 2 - 1 2 C h a p t e r 2 : B I O S s e t u p C h a p t e r 2 : B I O S s e t u p C h a p t e r 2 : B I O S s e t u p C h a p t e r 2 : B I O S s e t u p C h a p t e r 2 : B I O S s e t u p
2.3.5 2.3.5 2.3.5 2.3.5 2.3.5 Primary and Secondary IDE Master/Slave Primary and Secondary IDE Master/Slave Primary and Secondary IDE Master/Slave Primary and Secondary IDE Master/Slave Primary and Secondary IDE Master/Slave
Primary IDE Master
x Auto Acoustic Management Disabled
Primary IDE Master [Auto]
Access Mode [Auto]
Capacity 13579 MB
Cylinder 26310
Head 16
Sector 63
PIO Mode [Auto]
UDMA Mode [Auto]
Transfer Mode UDMA 4
Select Menu
Item Specific Help
Press [Enter] to
select.
The BIOS automatically detects the values opposite the dimmed items
(Capacity, Cylinder, Head, Sector, and Transfer Mode). These values are
not user-configurable. These items show N/A if no IDE device is installed in
the system.
Auto Acoustic Management [Disabled] Auto Acoustic Management [Disabled] Auto Acoustic Management [Disabled] Auto Acoustic Management [Disabled] Auto Acoustic Management [Disabled]
This option allows drive noise reduction.
Configuration options: [Disabled] [Minimum] [Medium] [Maximum]
Primary/Secondary IDE Master/Slave [Auto] Primary/Secondary IDE Master/Slave [Auto] Primary/Secondary IDE Master/Slave [Auto] Primary/Secondary IDE Master/Slave [Auto] Primary/Secondary IDE Master/Slave [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, the BIOS automatically fills in the correct values for
the remaining fields on this sub-menu. If the hard disk was already
formatted on a previous system, the setup BIOS may detect incorrect
parameters. Select [Manual] to manually enter the IDE hard disk drive
parameters. If no drive is installed select [None].
Configuration options: [None] [Auto] [Manual]
Access Mode [Auto] Access Mode [Auto] Access Mode [Auto] Access Mode [Auto] Access Mode [Auto]
The default [Auto] allows automatic detection of an IDE hard disk drive.
Select [CHS] for this item if you set the IDE Primary Master/Slave to
[Manual]. Configuration options: [CHS] [LBA] [Large] [Auto]
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.