Asus Z9PE-D16 - Manual (Page 152)

6-8 Chapter 6: Driver installation
3. Select Yes using the key when asked if you have the driver disk, then
press .
Main Menu
Do you have a driver disk?
Yes No
4. Insert the Red Hat ® Enterprise RAID driver disk to the USB floppy disk drive,
select OK, then press .
The drivers for the RAID card are installed to the system.
Insert Driver Disk
Insert your driver disk into /dev/fd0
and press “OK” to continue.
OK Back
Red Hat ® Enterprise Linux OS 5.6
To install the LSI MegaRAID controller driver when installing Red Hat ® Enterprise
OS:
1. Boot the system from the Red Hat
® OS installation CD.
2. At the boot:, type linux dd noprobe=ata1 noprobe=ata2..., then
press .
The number of ata varies with the hard disk drive number you have when
building a RAID set. For example, if you want to build a RAID set with 6 hard
disk drives, type command line: linux dd noprobe=ata1 noprobe=ata2
noprobe=ata3 noprobe=ata4 noprobe=ata5 noprobe=ata6.
- To install or upgrade in graphical mode, press the key.
- To install or upgrade in text mode, type: linux text .
- Use the function keys listed below for more information.
[F1-Main] [F2-Options] [F3-General] [F4-Kernel] [F5-Rescue]
boot: linux dd noprobe=ata1 noprobe=ata2