beautypg.com

Bios setup, 2 i/o device configuration – Asus E500-CS User Manual

Page 60

background image

ASUS CUSI-FX User’s Manual

60

4. BIOS SETUP

4. BIOS SETUP

Onboard AC97 Modem Controller [Auto]

[Auto] allows the motherboard’s BIOS to detect whether you are using any
modem device. If a modem device is detected, the onboard modem control-
ler will be enabled; if no modem device is detected, the onboard modem/
audio controller will be disabled. If you have conflicts with the onboard
modem controller, you may set the field to [Disabled]. Configuration op-
tions: [Disabled] [Auto]

Floppy Disk Access Control [R/W]

When set to [Read Only], this field protects files from being copied to floppy
disks by allowing reads from the floppy disk drive but not writes. The setup
default [R/W] allows both reads and writes. Configuration options: [R/W]
[Read Only]

Onboard FDC Swap A & B [No Swap]

This field allows you to reverse the hardware drive letter assignments of
your floppy disk drives. Configuration options: [No Swap] [Swap AB]

Onboard Serial Port 1 [3F8H/IRQ4]
Onboard Serial Port 2 [2F8H/IRQ3]

These fields allow you to set the addresses for the onboard serial connec-
tors. Serial Port 1 and Serial Port 2 must have different addresses. Configu-
ration options: [3F8H/IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10]
[Disabled]

4.4.2 I/O Device Configuration

I/O Device Config

This manual is related to the following products: