Dayton Audio DSS3-SN Satin Nickel Spike Set 4 Pcs. - Manual

1. Drill four 5/16” diameter holes. Position the holes
approximately 1-1/2” from the corners. (See fig. 1)
2. Install barbed inserts
NOTE: The barbed inserts can be installed from
either the inside or outside of the cabinet.
A) Set barbed insert in the hole and finger tighten.
Use a 6 mm hex wrench (not included) to tighten
barbed insert until it is snug. (See fig. 2)
B) Repeat procedure for the other pre-drilled holes.
3. Install spikes
A) Thread the threaded stud into the hole, leaving
approximately 5/16” protruding above the
surface. (See fig. 3)
B) Remove the tip of the spike and hand tighten
the cone foot on the threaded stud until it is
snug against the bottom of the cabinet.
NOTE: If the threaded stud starts to turn with the
foot, use a screwdriver (not included) to hold it in
place while hand tightening the foot. (See fig. 4)
C) Re-install the tip on the cone foot and repeat this
procedure for the other feet.
D) Squeeze a small amount of silicon sealant “RTV”
into each hole to help provide a good seal after
the spike is installed.
E) Repeat procedure for the other spikes.
Speaker Spike
Installation
daytonaudio.com
Inside
Cabinet
Outside
Cabinet
(Fig. 1)
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 1)
(Fig. 2)
(Fig. 3)
(Fig. 4)