beautypg.com

Dayton Audio DSS5-BK Black Spike Set 4 Pcs. User Manual

Speaker spike installation, Inside cabinet outside cabinet

background image

1. Drill four 5/16” diameter holes. Position the holes

approximately 1-1/2” from the corners. (See fig. 1)

2. Install barbed inserts

NOTE: The barbed inserts can be installed from

either the inside or outside of the cabinet.

A) Set barbed insert in the hole and finger tighten.

Use a 6 mm hex wrench (not included) to tighten

barbed insert until it is snug. (See fig. 2)

B) Repeat procedure for the other pre-drilled holes.

3. Install spikes

A) Thread the threaded stud into the hole, leaving

approximately 5/16” protruding above the

surface. (See fig. 3)

B) Remove the tip of the spike and hand tighten

the cone foot on the threaded stud until it is

snug against the bottom of the cabinet.

NOTE: If the threaded stud starts to turn with the

foot, use a screwdriver (not included) to hold it in

place while hand tightening the foot. (See fig. 4)

C) Re-install the tip on the cone foot and repeat this

procedure for the other feet.

D) Squeeze a small amount of silicon sealant “RTV”

into each hole to help provide a good seal after

the spike is installed.

E) Repeat procedure for the other spikes.

Speaker Spike

Installation

daytonaudio.com

Inside

Cabinet

Outside

Cabinet

(Fig. 1)

(Fig. 2)

(Fig. 3)

(Fig. 4)

(Fig. 1)

(Fig. 2)

(Fig. 3)

(Fig. 4)