Media-Tech U-DRIVE MIRROR BT - Manual (Page 4)

4
EN Using the device
Plug in the charger, device will power on and start to re-
cord automatically. When device is powered on manually
press OK button to start/stop recording.
If you want to mark file as “read only” (when device is re-
cording in loop mode) press MODE button – padlock icon
will pop-up in the top of the screen.
Browsing recorded files using the PC
computer
In order to view recorded files put microSD card into card
reader of your PC computer, go to DCIM folder, use media
browser to play selected file.
Bluetooth pairing
When device is powered on pairing with smartphone or cell
phone is available. Enable searching for Bluetooth devices
on your smartphone, select item MT4046 from the list.
In most cases there is no need for password, however if
your smartphone is demanding password enter „0000” or
„1234”.
If you want to pair the device with another smartphone
press and hold BLUETOOTH button for 5 seconds, after
that start pairing procedure again.
Note. Some older cell phones with Bluetooth V2.0 and
lower may not work with MT4046 and can not be con-
sidered as malfunction.
Due to continuous development specification and appearance
of product are subject to change without prior notice. For tech-
nical support please visit www.media-tech.eu.
Phone call in hands-free mode
Use your smartphone buttons/touch panel to start/finish
phone calls. During call built-in speaker and microphone
of MT4046 will be used.