SCANTECH ID (Champtek company) V-1010BT - Manual (Page 72)

64
GS1 DataBar Expanded
GS1 DataBar Limited
5.2 Preamble and Postamble Insertion
5.2.1 Setup Insertion
To set the insertion of the output characters:
1. Scan the programming code of the desired set.
2. Scan the programming code of the desired symbology
3. Go to the Decimal Value Table in Appendix A. Scan
programming codes that represent the desired
position to be inserted (1: the first digit, 99:
the last digit).
4. Scan the “Complete” programming code of “Character
Position to Be Inserted”.
5. Go to the ASCII Table in Appendix C, Scan
programming codes that represent the desired
characters to be inserted.
6. Scan the “Complete” programming code of “Characters
to Be Inserted”.
Repeat the steps 1 – 6 to set additional insertion.
Example: Insert $ as Preamble for Code UPC-A.
Start Configuration
1
st
Set