SCANTECH ID (Champtek company) V-1010BT - Manual (Page 21)

13
4.2 Set All Default Parameter
By scanning “Set All Default” label, the all parameters
will go back to the factory default settings for scanner
and cradle.
After reading a valid programming code the scanner will
give three high beep and the Green LED indicator will
light on.
Set all the parameters to the
factory default settings
4.3 General Process
1 Power up the Scanner
2 Scan the Start Configuration bar
code
3 Scan the bar code for the desired feature.
4 Scan End of Configuration bar code
5 Scan Save Parameters bar code