SCANTECH ID (Champtek company) FI300 - Manual (Page 7)

3.3 USB Driver
In case you will use the device with USB Virtual
COM port emulation, please contact with your
dealer and download the correct USB driver for
Virtual COM port. Since it is necessary to install the
USB driver on your Host system and operate
correctly between the device and your system.
3.4 Switching Cable
Before removing the cable from the scanner, it’s
recommended to turn off the power of the host
system and the power supply has been
disconnected from unit.
1) Find the small “Pin-hole” on the bottom of the
unit.
2) Use a bended regular paperclip and insert the
tip into the hole.
3) You will hear a “click”, then gentle on the strain-
relief of the cable and it will slide out of the
scanner.
5